Start-up and Shut-down of Thermoforming lines. Change extruder screen packs. Fill roll-stand and extruder water tanks if required. Check part quality for defects as often as time permits and if needed, correct accordingly. Pull one shot of parts at the beginning of the shift and turnover to quality assurance. Ensure operators and operator assistants are performing their duties correctly. Fill out “Material Percentages Sheet” and turnover to a Lead-person to be recorded in the Thermoforming Traceability system. Manage ConAir systems to ensure proper material percentages are being used in production. Keep regrind in the day bins at a comfortable operating level. Ensure all production equipment is operational and perform minor repairs if necessary. Notify Thermoforming Maintenance if a machine failure occurs. Maintain the department in a clean and orderly manner. Record production results at the end of the shift in the WebEFF system. Maintain and enforce all company safety, environment and Department of Health requirements
High school diploma / GED Equivalent. Strong organizational skills with proven ability to complete multiple tasks simultaneously. Prior Thermoforming experience preferred. Able to stand/walk for 7 hours of an 8-hour shift. Able to work overhead or in awkward positions on a frequent basis. Ability to occasionally climb ladders / steps safely and without assistance. Ability to lift 50 pounds frequently and/or up to 100 pounds with assistance occasionally. Ability to push/pull loads in excess of 100 pounds occasionally. Ability to occasionally climb on and off a forklift safely and without assistance. Ability to safely operate a forklift in high traffic, low clearance areas while not posing a safety risk to others. Applicant must not be at risk of sudden alterations in consciousness. Hearing sufficient to recognize and respond to shouted warnings, alarms and horns on forklifts. Verbal communication adequate to use a radio and or paging system to contact other co-workers in other areas of the complex. Able to use both hands for effective manipulation of tools/parts. Stereoptic vision of 20/40 or better and peripheral vision of 70 degrees or greater and ability to read 10-12 point font at a distance of 12-18 inches. Bending and lifting ability adequate to shovel material. Ability to work in dusty / smoky environment on an intermittent basis. Proven ability to lead, motivate and direct employees. Ability to read micrometers and calipers.
Location Evansville, IN 47710 US (Primary)
Shift Type Category Maintenance / Automation / Process Technicians Career Level Associate Job Classification Hourly Travel 0 - 10% Exemption Type Education High School or GED Salary Range
Location/Region: Evansville, IN (US)